U.light by LAB23

The U.LIGHT bollard is made out of cold galvanised and polyester powder coated, thickness 20/10 steel, (or in stainless steel AISI 304).
U.LIGHT.1 consists of a d 152 mm tube, laser cut on the upper side, with an inclination of 46 degrees where a plate is fixed through a continuous wire welding and then coated to make the weld invisible.
There is a flange with four M10 holes welded to the bottom of the bollard for ground fixing with appropriate bolts. The in-ground version is supplied with a 250 mm extension under the flange, which has no holes.

LED lighting version:
U.LIGHT.1 can be supplied with a LED lighting. In this case the tube bar is laser cut, obtaining a piercing 10x200 high, with an internal opal polycarbonate plate. A galvanised steel structure with the LED light device is situated inside the bollard.

Dimensions:
H = 450/800 mm
Bollard = 152 mm
Flange = 230 mm

The U.LIGHT.2 bollard is in cold galvanised and polyester powder coated steel or stainless steel AISI 304, thickness 20/10.
U.LIGHT.2 consists of a tube bar with a diameter of 152 mm, laser cut on the upper side, with an inclination of 46 degrees where a plate is fixed through a continuous wire welding and finally coated. This makes the welding invisible.
U.LIGHT.2 is supplied with a LED lighting. 10x350 mm high holes are laser cut where two opal polycarbonate plates are placed. Inside the bollard there is a structure made of a squared section 40x40 mm, in galvanised steel on the top of which is fixed the LED light device.
There is a flange with four M10 holes welded to the bottom of the bollard for ground fixing with appropriate bolts. The in-ground version is supplied with a 250 mm extension under the flange, which has no holes.

Dimensions:
H = 850 mm
Bollard = 152 mm
Flange = 230 mm