hop hop by miramondo

Hop hop - up on the wall!
“hop hop” is a broad range of products that can be used in a variety of ways. Thanks to their straightforward design, they can be mounted on walls and external steps etc. By means of additional brackets, “hop hop” can be cemented into the ground as a freestanding element or mounted on walls. By combining differing lengths of wood with the corresponding side pieces, a variety of arrangements is possible. One remarkable feature is the formal resolution of the intersection between the seat and the back rest. By means of the vertical wooden slat on the frontal edge of the seat, “hop hop” merges with the surface beneath and conceals sharp or unsightly wall edges.

Side Elements
Two different side pieces are available: with or without back rests. These are made of stainless steel. The laser-cut elements are welded on the inside. The surface is then brushed and given a high-quality, silk-matt finish.

Fixation
The seats are simple to mount on walls and other horizontal surfaces using four screws and four special raw plugs with internal metric coarse thread. For the freestanding, cemented and wall-mounted variations, we supply the relevant brackets and fasteners. The wooden slats are connected to the side pieces by means of a special screw fastener that can only be taken apart with a specific tool, thus protecting against vandalism.

Wooden Slats
The larch wood slats are available in three sizes: 640, 1490 and 1940 mm.
The wood is of an excellent quality: virtually free of knots, no heartwood, splinters, resin galls or splits. Cut, planed, with all edges rounded, the slats are available in two versions:
- with a water-based glaze
- untreated